Kaoko Cruise Controls are purpose-built for a variety of motorcycles over 600cc. They consist of a friction nut that is integral with a replacement handlebar-end weight.To install, just remove the right hand bar weight, replace it with Kaoko's bar weight, and firmly tighten the central retaining screw.
Note: Only fits Triumph Bonnevilles with 1" handlebars. (Some Bonnevilles have 7/8" bars.)
- Greatly reduces rider fatigue and strain on hand and wrist
- While cruising, rider is able to remove hand from throttle grip, throttle opening will remain as set
- Very simple to operate, even with heavy winter gloves
- High quality, compact and durable design, super smooth action
- Takes less than 5 minutes to fit
- Very little maintenance is required
- Less wear and tear on throttle cables and linkages
- Can result in reduced fuel consumption
Triumph Bonneville America
Triumph Bonneville T100
Special Installation Note: The handle bar in some cases on the motorcycle may not protrude sufficiently from the throttle sleeve. In a case such as this the throttle sleeve may be clamped as if the Control is engaged when in fact that is not the desired condition. The thrust washer is designed to an interior diameter large enough to fit OVER the handlebar end and engage the throttle tube.
To correct the problem is a simple matter of loosening the clamping screws of the throttle assembly and moving the assembly a few milimeters so that the handle bar protrudes approx 3mm out of the end of the plastic throttle sleeve. Tighten the clamp screws of the throttle assembly and fit the control per the Kaoko fitting instructions. You may need to make a final adjustment to the position of the throttle assembly if necessary.
Kit does NOT include a replacement left-side bar end weight.
Kaoko Safety Warning: The Kaoko Cruise Control is an aftermarket accessory. Any misunderstood, abused or incorrectly installed motorcycle accessory is a safety hazard that could cause injury or death. Its the riders responsibility to understand the operation and purpose for which the Kaoko Cruise Control is designed, namely, for cruising, only when safe to do so. At all other times the control should be disengaged. The Kaoko Cruise Controls are to be used only by experienced and responsible riders.
U.S. Pat. No. US D593,462 S
U.S. Pat. No. US D593,463 S
U.S. Pat. No. US D593,464 S