Cart - $0.00

You have no items in your shopping cart.

YouTube Facebook Twitter 855-255-5550 Email Us

How to re-sync your Coocase iLoc remote control to your V28, V36, or S48 Coocase topcase

Posted on Jpm7000000pmThu, 15 Jul 2010 20:45:01 +000010 4, 2016 by TwistedThrottle.com There have been 0 comments

If you've replaced your batteries in your Coocase remote or replaced the remote itself, you may need to re-sync it. This article explains how.

Step 1 - locate the iLoc unit inside the rear of the topcase

Step 2 - differentiate the Reset Button from the Alarm Sensitivity Dial

"A" is the Reset Button (located on the brake side of the iLoc)

"B" is the Alarm Sensitivity Dial (located on the clutch side of the iLoc)

Turn dial left (counterclockwise) to decrease alarm sensitivity.

Turning all the way counterclockwise disables the alarm.

Turn dial right (clockwise) to increase alarm sensitivity.

Step 3 - Hold the Reset Button (button "A") until it beeps (approximately eight seconds). This indicates that the memory is cleared. You can now synchronize up to two remote controls to the iLoc.

Step 4 - Hold the reset button until it beeps (approximately two seconds), then hold either button on the remote control until a beep is heard on the iLoc. The remote is now synchronized.

Warning: Unnecessarily pressing the reset button will cause your remote control to become unsynchronized with the iLoc system.

This post was posted in Coocase Topcases

Chat with us!