For 7/8"-diameter handlebars with 4.75" to 4.9"-long open-ended original grips (the most common grip size for sportbikes, enduros, and scooters).
Maximum power consumption of 48 watts per pair (4.0 amps at 12-volt DC).
Grips heat up to 131 degrees Fahrenheit (55 degrees Celsius) - wear gloves while riding as this can be uncomfortably hot on bare skin!
Grips are 125mm (4.9") long.
Fits bikes with 4.75" to 4.9"-long original handlebar grips. If you'd like a longer grip (5.25" or 5.75" long), check out Heaterz Heated Grips.
Includes waterproof electronic controller with following features:
- 5 power settings (100%, 75%, 40%, 30%, off);
- LED indicates current power setting;
- Automatically turns grips off when bike is turned off (when battery voltage drops below 11.5 volts), preventing accidental battery drainage - no need to install a relay!
- Double-stick tape included for flush mount of controller on fairing;
- Includes bracket for mounting controller on left-side handlebar control mount bolts (pre-drilled for two M6 mounting screws spaced 31mm-35mm apart on center)
- Controller size: 56mm wide x 54mm tall x 20mm thick
Includes fused, pre-terminated wiring harness with two 1.4"/M6 ring terminals for connection to your motorcycle's battery. No wiring tools are required for installation - simply plug the grips and controller into the included wiring harness, attach two wires to your battery terminals, and the wiring is finished!
Includes a tube of high-temperature epoxy for installing grips.
These heated grips have bored-out ends and are designed for easy installation on bikes with bar-end weights or throttle locks.
If your bike does not currently have bar ends, you can still install these grips, but your bar ends will remain open. To close your open bar ends and reduce handlebar vibration at the same time, bar end weights and throttle locks are available from Kaoko and can be used with these heated grips.
To prevent the battery of the vehicle from being completely discharged when the engine of the vehicle is turned off, the controller has software that turns off the heated grips before the battery voltage becomes too low to restart the vehicle. This voltage is set to 11.5 volts. This is meant as an "idiot protection" feature, but not as the normal daily way to turn your grips on and off. You should still turn off the heated grips manually before turning off your bike for the following reasons:
(1) If you plug you bike into a battery tender, the voltage on your battery will read 14.4 volts, and the grips will never turn off automatically.
(2) Leaving the grips turned on when the bike is parked for an extended period of time may cause the grips to overheat and cause damage to the grips, even if the battery doesn't get drained.
To prevent the grips from being turned on by accident, the Controller will not switch on unless there is sufficient battery voltage (12.0 volts). Usually the switch will only turn on if the vehicle is running. If the voltage is insufficient to start the grips, a blue LED on the controller will flash 5 times to indicate the problem when you try to turn them on.
Simply put, this is the most complete, easy to install heated grip kit currently on the market, and it's available at a great price (less than 1/3 of the price of most OEM heated grip kits).
Most other brands are more expensive, require difficult wire soldering/crimping or drilling your handlebars, don't include all required wiring supplies (like relays and fuse holders), and take a great deal more time to install. There's not a lot to say about this grip kit because it just works - it addresses all the gripes we've always had about aftermarket heated grips.
Need more info? Check out WebBikeWorld's independent review of Oxford Heaterz heated handlebar grips
Special Note: Oxford heated grip cannot be cut down, element runs through entire grip.
Confirmed fit list:
RSV1000 Mille / Factory
F650 Funduro & ST
F650GS & F650 GS/Dakar, -'07
G650 Xchallenge, Xcountry, & Xmoto
Firebolt XB9R & XB12R
Lightning XB12s, XB12Scg, XB12Ss, XB9SX, XB12STT
Ulysses XB12X & XB12XT
Elephant 750 / 900
Gran Canyon 900, '98-
600SS, 750SS, & 900SS Super Sport
748 / 916 / 996 / 998
749 / 999
851 / 888
Monster (all models 600 to 1000cc)
S2, S2R, S4, & S4R
Multistrada 620DS, 1000DS, & 1100
ST4 and ST4S
599 / CB600 Hornet
919 / CB900 Hornet
CRF230L & CRF230M
Goldwing GL1500 (may be slightly shorter than original grips)
Goldwing GL1800 (may be slightly shorter than original grips)
ST1100 Pan European
ST1300 Pan European
VFR800 Interceptor (all years)
VTR1000 SP2 RC51
Ninja 250R / EX250 / ZZR250, all years
Ninja 500R / EX500 / ZZR500, all years
Ninja 650R / ER6F
Super Sherpa KL250G
Z750S & Z750
ZRX1200R & ZRX1100
ZX6, all years
ZX6R, all years
ZZR600, all years
ZX10R, all years
ZX11 Ninja / ZZR1100
Concours GTR1000 / ZG1000
LC4 Adventure, Enduro, and all other models
LC8 Adventure 950 & 990
LC8 Supermoto 950
LC8 Superenduro 950
Super Duke 990
All other models
Breva V850 & V750
V11 LeMans, Sport, and Sport Naked
All other models
Beverly BV200, BV250, BV400, & BV500
MP3 125, 150, 250, 400, & 500
All other models
Bandit GSF600, GSF650, GSF1200, & GSF1250
DRZ400 & DZR400SM
GSX600F & GSX750F Katana
GSXR600, all years
GSXR750, all years
GSXR1000, all years
Hayabusa GSX1340R, '08-
Hayabusa GSX1300R, -'07
SV650, all years
SV1000, all years
Daytona 600, 650, 750, 900, 1000, & 1200
Speed Triple (all models)
Sprint RS & ST 955
Street Triple 675
FZ1, all years
R1, all years
R6, all years
TDM850 & 900
V-Max 1200, -'08
V-Max VMX17, '09-
XJ600 & XJ900
YZF600R Thundercat, '96-