Cart - $0.00

You have no items in your shopping cart.

YouTube Facebook Twitter 855-255-5550 Email Us

SW-MOTECH Quick-Lock EVO Contour Side Carriers to fit GIVI V35 PLX Side Cases for Kawasaki Ninja 1000 '11-'18

SW-MOTECH Quick-Lock EVO Contour Side Carriers to fit GIVI V35 PLX Side Cases for Kawasaki Ninja 1000 '11-'18

4 Review(s)
SKU: KFT.08.184.16000.B

In stock

Only 6 left

Customer Reviews

4 Item(s)

per page
Review by James
Purchased SW-MOTECH rack system for my 2014 Ninja 1000 ABS back in May of 2014 after I purchased the new bike. Instructions were dead on, but you also need to be a bit mechanically inclined to do the install. The twisted throttle video of the R&G tidy tail install was helpful in taking apart the rear of the bike for the relocation of the rear turn signals. I also used the same video in finding a "switched" power source for the install of my Twisted Throttle Power Hub. The red wire depicted in the video that leads to the tag light was the wire that I tapped into for a switched power source. Thanks TT (Posted on 9/20/2014)
Review by levesl
Installation was easy, great fit and look real good. I did not go like instruction say's for the flasher wire. I pass the wire in the tail section going out right under the license plate light, it look much better. (Posted on 8/27/2014)
Review by Norskie
I got this installed. Like all things SW-Motech, the quality is excellent. But note that the sideracks are NOT tubular, as in the photo .. they are made of flat steel (I've attached a photo).

These are different from the Kawasaki mounting racks, in that they don't buttress the rear subframe. Also, the factory racks includes one more mounting point. What this means is that the factory racks are stronger. If you carry a passenger or plan to exceed the recommended 10kg / 22lbs then the factory rack is a better choice.

The instructions have two minor errors:

1. It depicts the top mounting bracket installed with the quick-lock hole above the passenger grab rail; it must be under it (I've attached a photo).
2. There is nothing which illustrates the middle plastic screw which attaches the PLX case carrier to the mounting bracket.

Also .. the kit comes with turn signal wire extenders, but by drilling a small hole under the license plate light and installing a grommet, I was able to route the wires without modification (it was a tight fit though). (Posted on 7/23/2014)
Review by Kevin
Just installed these on my Ninja 1000. Takes a fair amount of time but well worth it. Fit,finish and appearance are quite good. Easily removed in a matter of seconds. Shipping was prompt and all items received as ordered.++ (Posted on 2/5/2013)

4 Item(s)

per page
Write Your Own Review

Only registered users can write reviews. Please, log in or register

Chat with us!