Ergonomics & Rider Comfort

For use with original top clamp. Adds an additional 20mm of rise to the bar height without changing of control cables, wiring, or hoses. However, the installer should always check for adequate cable/wiring/hose slack during installation. Available in polished silver finish.


Learn More

Provides a more upright, comfortable riding position by raising the original handlebar by approximately 25mm (1 inch). No need to replace your handlebars - simply remove the original top clamp, place the riser between the handlebar and original bottom clamp, and reinstall top clamp using included hardware. No change of control cables, wiring, or hoses is required. It is recommended that the installer should check for adequate cable/wiring/hose slack during installation. Learn More

Includes one pair of handlebar risers (30mm riser height) with a powdercoated black finish. No front brakeline extension is necessary for use of handlebars in their original rotational position within the handlebar clamps; however, if you roll your handlebars further rearward within the handlebar clamps, you may need to extend the front brakeline if using this handlebar riser. Learn More

The risers are placed between the fork crown and the handlebars to raise the bars up 1 " (25mm) and back 1/2 " (12.5mm). This will help to relieve wrist and neck pain on long rides. Requires no change of any control cables, wiring, or hoses. Learn More

The risers are placed between the fork crown and the handlebars to raise the bars up 2" (51mm) and back 1_1/4" (32mm). This will help to relieve wrist and neck pain on long rides. Requires no change of any control cables, wiring, or hoses. Learn More

Includes one-piece handlebar riser block (20mm rise height) in black, and longer screws.

No modification of brake lines is necessary for installation. Learn More

Provides a more upright, comfortable riding position by raising the original 1-1/8" (28mm) diameter tubular handlebar up 20mm and back 30mm. No need to replace your handlebars - simply remove the original top clamp, place the riser between the handlebar and original bottom clamp, and reinstall top clamp using included hardware. Also perfect for use with oversize handlebars (ProTaper, Magura, etc.). Learn More

The risers are placed between the fork crown and the handlebars to raise the bars up 2" (51mm) and back 1_1/4" (32mm). This will help to relieve wrist and neck pain on long rides. Requires no change of any control cables, wiring, or hoses. Learn More

The risers are placed between the fork crown and the handlebars to raise the bars up 1 1/4" (32mm) and back approximately 5/8" (17mm). This will help to relieve wrist and neck pain on long rides. Longer bolts are supplied. Requires no change of any control cables, wiring, or hoses. Learn More