Electrical Connection LED Motorcycle Battery Voltage Monitor (flush mount kit)
Item No: EC.04101
| Our Price: | $29.95 |
Electrical Connection LED Motorcycle Battery Voltage Monitor (flush mount kit)
Proclaimed as an "Innovation of the Month" by Motorcycle Consumer News and the "Smart Idiot Light" by another leading magazine editor, this is the smallest and simplest monitoring device available. It's also more than a light that comes on after it's too late; it's a unique and cost effective voltage indicator.
A 1/4" (T1 3/4) LED displays voltage levels using colors in a stoplight style arrangement: RED - less than 11.5 volts, AMBER - 11.9 to 11.5 volts, and GREEN - 12 volts and up. Fuse protection, wiring, connector assortment and complete instructions are included. Simple 2 wire installation. Remember, GREEN means GO, AMBER is WARNING, RED means STOP! Designed for installation on bikes with a fairing or for custom installation. Drilling a single 1/4-inch hole is required to install the flush-mount LED in any flat surface near your instrument panel.
Comments (1)
05.20.2011 17:13 » Works As Advertised But .... Richard Garner
Admin note: This is a dedicated thread for discussing the Electrical Connection LED Motorcycle Battery Voltage Monitor. I installed this device on my '09 KLR650E. The wiring was simple and I hooked it into the low beam wire at the fuse box so that it would only display when the key was on. The dash mount was simple but not elegant as there's no fitting included with the kit for flush mounting the indicator except for a couple of Honda models. I believe I'll finish mine off with a small amount of silicone sealer as it's presently just sticking out of the hole I drilled. Also, the indicator/harness connection works but doesn't seem very secure. At least if it falls apart, the bike will still operate OK. As far as I can tell, the voltage indication seems accurate but I didn't cross check it with a voltmeter.