Handlebar risers (KTM LC4 Adventure, '01-, LC8 Adventure 950 & 990, & LC8 990 SuperMoto with original 22mm or 28mm handlebar) by SW-MOTECH

Provides a more upright, comfortable riding position by raising the original 7/8" (22mm) or 1-1/8" (28mm) diameter tubular handlebar by 30mm (1.2"). No need to replace your handlebars - simply remove the original top clamp, place the riser between the handlebar and original bottom clamp, and reinstall top clamp using included hardware.

For use with original top clamp. No change of control cables, wiring, or hoses is required for most motorcycles however, the installer should always checking for adequate cable/wiring/hose slack during installation.

Available in silver (s). Sold as a pair.

Fits all bikes with OEM KTM telescopic fork bridge parts as shown in the fiche diagram on this page:
39 - 590.01.039.000 handlebar support for 22mm bar, OR
4383021-001 handlebar support for 28mm bar

38 - 590.01.038.000 handlebar top clamp for 22mm bar, OR
4383019-001 handlebar top clamp for 28mm bar

34 - 584.01.034.218 fork bridge

Kit consists of two 28mm H x 25mm OD x 10mm ID spacers and two M10 x 100mm hexagon socket screws.

For KTM bikes that use an OEM handlebar holder set from MAGURA. If the bottom part of the handlebar holder set is attached by two screws to the fork, then you can use the LEH.00.039.106 handlebar riser.

Check photo of bottom clamp on this page to be sure this bar riser kit will fit.

Works on same bikes as LEH.00.039.105.

Confirmed bike fit list:
LC4 400, 2000
LC4 640, 2000
LC4 Adventure 640, 2007 (requires add-on KTM screw kit)
LC4-E 640 SIX DAYS, 2002
LC4 Super Moto, 2000
LC8 Adventure 950, all years
LC8 Adventure 990, all years
LC8 Adventure 990 SuperMoto, all years