Oxford Hothands Essential Heated Overgrips
Item No: OXF.OF694
| Our Price: | $54.95 |
Manufacturer: www.oxprod.com
Wrap these quickly and go! This heated grip solution allows you to keep the existing grips on your motorcycle and add heat when needed. Secured with a hook and pile grip strip.
- All necessary fittings are included in this easy-to-fit package
- A switch is included with LED warning light
- Very low battery drain
- 2 year guarantee
Customer Testimonial: Kenneth K I had purchased the Hothands Overgrips and found them very easy to install on my Suzuki AN400 (2008). Instructions were clear & simple and easy to follow. Just remove the handlebar covers, place the Hothands on each grip, snake the wires along each of the handlebars and use the included zip-ties to tie the excess wire to the bars. The control unit has double sticky tape and also mounts easily. The 2 lead wires, I attached directly to the battery for ease of installation (so do not make the mistake of NOT shutting off the grip heaters when dismounting the scooter!) I drilled a hole in the battery cover large enough to accommodate both wires and simply attached to each battery terminal.
The grips, themselves heat up very quickly and although there is no heat control, other than the ON or OFF switch..You must wear gloves to avoid burning your hands..as they do get quite hot.... Overall..I would rate them a 9 out of 10, due to the lack off an adjustable heat controller.
Comments (1)
10.27.2010 07:30 » Opinion & experience with Hothands Essential Heated Overgrip KENNETH KUBLIN
Admin note: This is a dedicated thread for discussing the Hothands Essential Heated Overgrips. I had purchased the Hothands Overgrips and found them very easy to install on my Suzuki AN400 (2008). Instructions were clear & simple and easy to follow. Just remove the handlebar covers, place the Hothands on each grip, snake the wires along each of the handlebars and use the included zip-ties to tie the excess wire to the bars. The control unit has double sticky tape and also mounts easily. The 2 lead wires, I attached directly to the battery for ease of installation (so do not make the mistake of NOT shutting off the grip heaters when dismounting the scooter!) I drilled a hole in the battery cover large enough to accommodate both wires and simply attached to each battery terminal. The grips, themselves heat up very quickly and although there is no heat control, other than the ON or OFF switch..You must wear gloves to avoid burning your hands..as they do get quite hot.... Overall..I would rate them a 9 out of 10, due to the lack off an adjustable heat controller.