Cart - $0.00

You have no items in your shopping cart.


SW-MOTECH Crash Bars Engine Guards for Ducati Multistrada 1200 '10-'14

SW-MOTECH Crash Bars Engine Guards for Ducati Multistrada 1200 '10-'14

$215.95 $183.56
SKU: SBL.22.142.10000.B

Out of stock but more on the way. Order now for fastest delivery.

Email me when back in stock


Email Me When Back In Stock

Enter your email below and we'll notify you when it is back in stock.


SW-MOTECH Crash Bars are designed to protect your motorcycle during an unexpected drop.

Understanding Crash Bars


Constructed of heavy-duty mild steel, SW-MOTECH crash bars are designed to provide maximum protection, optical integration, and high-quality fit and finish.
Manufacturer # SBL.22.142.10000/B

You may also be interested in the following product(s)

Customer Reviews
Review by Guest
Fits well. Easy to install. Looks good and adds some protection. My only improvement suggestion: I would like to see a bar crossing between the guards that helps reinforce the guards and protect the rad a little better. (Posted on 10/6/2018)
Review by shil
I'm 6'3" and was a little concerned my knees would hit the crash bars. No worries.
Easy install. No concerns at all. (Posted on 5/23/2016)
Review by pete49sea
Great fit and finish. You need an 1/2-in drive socket to remove the washer from the screw that holds up the motor. Other than that with basic tools installation is a piece of cake.
It would have been nice to also have some bolt covers. (Posted on 10/9/2015)
Review by DavidC
Customer submitted photos of his Multistrada after an 80MPH get off! The SWMotech crashbars, R&G sliders and Barkbusters did their job in grand fashion! (Posted on 3/9/2015)
Review by Sparky
The fit and finish were quite good. Instructions were correct, but minimal.

You will need to tap (i.e. hammer) out the long bolt that goes through the engine after removing the nut on the right side. Do not try to rotate the bolt, take off the nut! Being paranoid, I put a jack under the engine before removing the bolt to keep the engine from shifting, but this is probably not necessary.

Note that bars are made from 1.08" diameter tubing. This makes it difficult to use standard clamps which are typically made for 1" or 1.25" tubes. I did manage to get some 1" clamps to fit after a bit of bending. Your results may vary. (Posted on 10/22/2014)
Review by Anonymous
I just installed these on my '13 Multistrada 1200 yesterday, and it was much easier than I feared! The bars themselves aren't as heavy as some and are very well made, fit just perfectly. (Posted on 7/7/2014)
Write Your Own Review

Only registered users can write reviews. Please, log in or register

Chat with us!